14.HANDLEBAR/FRONT WHEEL/FRONTBRAKE/ FRONT SHOCK ABSORBER/STEERING STEM DINK 50/125 HANDLEBAR REMOVAL Remove the lower handlebar cover and front cover (refer to the "FRAME COVERS REMOVAL/INSTALLATION" section in the chapter 2). Remove the two bolts (1) and disconnect the brake light switch wire (2), then remove the rear brake master cylinder. Remove the two bolts (3) and disconnect the brake light switch wire (4), then remove the front brake master cylinder. Remove the inner cover (refer to the "FRAME COVERS REMOVAL/INSTALLATION" section in the chapter 2). Disconnect the right and left handlebar switch connectors (5). Remove the handlebar lock nut (6) and take out the bolt (7). Remove the handlebar and collar (8). 14-4