11.FINAL REDUCTION/ TRANSMISSION SYSTEM UXV 500 Install and tighten the nut to the specified torque by using the special tool. Torque: 11 kgf-m (110 N-m, 79.2 lb-ft) Special tool: Nut wrench A120E00066 Apply clean engine oil to the new oil seal lip then install the oil seal. Oil Seal Nut FRONT SIDE BEARING Remove the oil seal. Remove the snap ring. Oil Seal Snap Ring Remove the bearing by using the special tool. Special tool: Bearing Puller A120E00037 Install the new bearing by using the special tool. Special tool: Bearing driver A120E00014 Bearing Puller Bearing Driver 11-15