grand dink 125 mmc 1 Manual-de-oficina : pagina 167

                    13-1. FUEL SYSTEM/CARBURETOR/
    FUEL PUMP/ FUEL TANK                                               GRAND DINK 125/150



                                                  Outlet Tube    Vacuum Tube     Inlet Tube
 FUEL PUMP INSTALLATION
 Install the fuel pump and secure it with the
 two bolts.
 Connect the fuel pump inlet, outlet and
 vacuum tubes.
 Install the seat, met-in box and frame center
 cover.




                                                 Fuel Pump               Fuel Strainer


                                                       Fuel Pump               Outlet Tube
 Measure the fuel pump output.
 Start the engine and disconnect the fuel
 outlet tube and place a clean container under
 the tube to check the fuel output.
 Output: 40cc/1500rpm/10 seconds .




                                                                               Container


                                                   Fuel Unit       Fuel Vapor Tube
 FUEL TANK REMOVAL
 Remove the floor board. ( 2-4)
 Remove the leg shield . ( 2-5)
 Disconnect the fuel unit wire connector.
 Remove the fuel tube between the fuel tank
 and the fuel filler.
 Disconnect the fuel vapor tube.
 Remove the fuel tank.
 The installation sequence is the reverse of
 removal.


                                                 Fuel Strainer            Tube to Fuel Filler


                                                                                     13-20
                
Usamos cookies em nosso site para coletar estatísticas sobre visitas. Ao clicar em Aceito ou continuando neste site, você aceita o uso desses cookies.